How to fix OBDSTAR X300 DP Plus error “DiagProgram has stopped”

OBDSTAR X300 DP Plus X300 PAD2 is a new Android-based vehicle trouble diagnostic device developed for internet applications.
A customer encountered such a problem while using obdstar dp plus: Carry out a SAS restore, OBDSTAR X300 DP PLUS has this error message Unfortunately, DiagProgram has stopped. Programming, real estate, odometer all the same and doesn’t work.

How-to-fix-OBDSTAR-X300-DP-Plus-error-DiagProgram-has-stopped-1
How-to-fix-OBDSTAR-X300-DP-Plus-error-DiagProgram-has-stopped-2
Then it shows us the version in ABOUT (VCI button below) as Autonumen technical support is required
How-to-fix-OBDSTAR-X300-DP-Plus-error-DiagProgram-has-stopped-3
Here comes the Solution: Settings->DP->Uninstall Updates, Clear Data, Clear Cache

How-to-fix-OBDSTAR-X300-DP-Plus-error-DiagProgram-has-stopped-4 How-to-fix-OBDSTAR-X300-DP-Plus-error-DiagProgram-has-stopped-5 How-to-fix-OBDSTAR-X300-DP-Plus-error-DiagProgram-has-stopped-7

 

How-to-fix-OBDSTAR-X300-DP-Plus-error-DiagProgram-has-stopped-6

How-to-fix-OBDSTAR-X300-DP-Plus-error-DiagProgram-has-stopped-8

If it doesn’t work, go to Settings-> Backup & Reset-> Restore factory settings
How-to-fix-OBDSTAR-X300-DP-Plus-error-DiagProgram-has-stopped-9

Solved!

 

If you have any problems, don’t hesitate to contact us, send email to sale@cnautotool.com.

Be the first to comment

Leave a Reply

Your email address will not be published.


*