V168 CAN Clip for Renault diagnostic software has been tested to work without any issue!
Purpose: This write-up explains how RenaultCLiP V168 works successfully!
Overview: About Renault Can Clip. You do not need to postpone your trip because of reprogramming or airbag issues that your Renault car is facing. With Renault CAN clip, you can scan and diagnose different problems that you car may have before a long trip.
Test scope:
– In Scope
– Out of Scope
A functionality verification which needs connectivity to a third party application cannot be tested, as the connectivity could not be established due to some technical limitations. This section should be clearly documented, else it will be assumed that Testing covered all areas of the application.
a) In Scope
Functional Testing for the following modules are in Scope of Testing
·Functions tested: OBDII diagnosis, ECU reprogramming.
·Systems tested: ENGINE, automatic gear shifting, Air conditioning system, SRS, ABS, ASR, MPL, GM, IMMO, KEYZESS GO system, OBD-I I, etc.
b) Out of Scope
Performance Testing was not done for this application.
·Renault can clip key programming
·Renault can clip ECU programming
Note: you can try FVDI2Renault or Renault-COM for programming.
Metrics:
A) No. of test cases planned vs executed
b) No. of test cases passed/failed
Test environment and tools:
Lessons Learned:
– Issues faced:
Connected to the car and four lights are lit Prompted for this content: 5800 window, units of measurement appear 104 Error 5800: Please check the power supply is connected, the normal connection indicator light red flashes. If it is any problem of these two situations: reconnect, wait about 10 seconds before verification.
– Solutions:
1) The installed software can’t run in your computer system stably, there is no communication between the software and the device.
2) The computer USB interface does not work, try to use another one.
Leave a Reply