CGDI Prog BMW MSV80 programs BMW F010: Works perfectly

Works perfectly

CGDI Prog BMW MSV80 is a good key programmer for BMW users. It not only supports CAS1-CAS4+ key matching, but also supports BMW E/ F Series Program and so on.

Here is the step-by-step guide to program F series with CGDI PROG BMW.

Step 1: Connect CGDI BMW with BMW car& PC

Step 2: Program F010 ECU

In detail…

Step 1: Connect CGDI BMW with BMW car& PC

Connect CGDI BMW Programmer with vehicle via OBD

Connect CGDI BMW to the PC via USB cable

program-bmw-f010-1

Step 2: Program F010 EC

Run CGDI prog BMW software

Go to BMW F/G Series Program -> DME2 (ECU Address: 12) -> Begin Program

program-bmw-f010-2

Prompt: ECU is about to be programmed, please ensure that car battery has enough power, the programming process, please keep the equipment cable connection.

Then press “YES”

program-bmw-f010-3

Note: Whether to backup coding data?

Click “YES”

Confirm if the following VIN is correct, and modify it in text box below if VIN not correct

program-bmw-f010-4

Programming the BMW ECU…

(It needs about 5mins)

program-bmw-f010-5

Prompt: Programming success

If you did not code after programming, please enter the “BMW F/G series coding” function to set the code, please ignore it when some modules (such as gateway) do not need to set the code.

Press OK

program-bmw-f010-6

Turn on the ignition switch, works well.

Job’s done!

Leave a Comment

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>