New upgrade of Super DSP3+ Odometer Correction Tool !

dsp3

DSP3+ Odometer TOOL full package (include all software and hardware)
Free 2021 update with DSP3+ Full version!
Adjusting kilometers with DSP3+
Popular milage programmer
Advanced device programmer
Conversion from Miles to Kilometers
Motorola device programmer
EEPROM device programmer

The most advanced odometer adjustment tool for professionals
The most complete version to cover odometer mileage adjustment, airbag reset, some immobilizer programming and radio decoding. No limitation on odometer software! Can be used as stand along device programmer to access any EEPROM and MCU found in automotive industry these days.

Software: 
“Full software” includes FULL ODOMETER and some AIRBAG/RADIO/ IMMO coverage using OBD2 and direct programming of EEPROMs and MCUs. For complete coverage advice with “Vehicle List” below.

Hardware: 
PDA main unit. Includes the full set of all available adapters: EEPROM, Motorola, NEC, TMS 374, HC711, HC908, 9(S)12 in-circuit, HC705, EWS, NDM457, ST624, TMS 370, CMM, OBD, JC, AVR/PIC, D80/160, Multiplex, C-04, Denso. Includes all connectors and clips: MERCEDES-38 connector, BWM-20 connector, BMW CAS cables, Mercedes cluster cable, FCA chrysler cable, SD card, WiFi adapter, SOIC8 clip, touch-holders (T-01, T-02, T-03, T-04), USB cable, power cables.

DSP 3+24-1

 

 

The instruction of DSP3+ software update

Please install ActiveSync software on your PC well before software update. Or please log in http://smelecom.com/sm/download.htm and download ActiveSync software and install it on your PC first of all.
6-1
The steps are similar among “Function Sync” and “Active Function” and “Software Update”, take “Software update” as an example:
1、Connect test connector and power supply well, shown as figure 1:
How to connect internet with wireless adapter of DSP3+Odometer Correction Tool-1
2、Click the red circle, and input the password, click button “ok”, shown as figure 2:
6-3
3、Connect USB cable to the dsp3+, shown as figure 3:
6-4

4、If your PC is windows XP operation system, set your ActiveSync software as figure 4.1:
6-5
If your PC is windows7 operation system, set your pc as figure 4.2:
6-6

5、XP operation system set successfully, shown as figure 5.1:
6-7
Windows7 operation system set successfully, shown as figure 5.2:
6-8
6 、 Click “Update” on the screen of DSP3+, and then click “SOFTWARE UPDATE’, shown as figure 6:
6-9

Click “YES” to start software update.
Note: this process will take about 30 minutes, during this time, do not disconnect the power supply , do not disconnect USB cable, do not change any settings on PC, wait patiently please.

7、About 30 minutes later, you will see “update successfully” on the screen of DSP3+, shown as figure 7:
6-10
Software update successfully.

 

https://www.cnautotool.com/category-5-b0-Mileage+Correction.html

 

 

Be the first to comment

Leave a Reply

Your email address will not be published.

*