Europe Ford Focus Mileage Programming after Replacement by Launch X431

This article show a guide on how to use Launch X431 to program mileage for Europe Ford Focus after instrument cluster replacement. This function is only necessary on newly installed instrument clusters.

The attention of the two points :
A,It is not possible to overwrite a value lower than the mileage.
B,If the odometer write failed, you can try again.

Procedures:
Diagnose:Select “Calling system” menu.
Europe-Ford-Focus-Mileage-Programming-after-Replacement-by-Launch-X431-1

Wait for 1 minutes. Then the Vehicles Specification screen displays.
Europe-Ford-Focus-Mileage-Programming-after-Replacement-by-Launch-X431-2

Select “ICM” menu
Europe-Ford-Focus-Mileage-Programming-after-Replacement-by-Launch-X431-3

Enter Odometer Write functions in the “SPECIAL FUNCTION” menu
Europe-Ford-Focus-Mileage-Programming-after-Replacement-by-Launch-X431-4

When selecting “Odometer Write”, it will display as below show.
Europe-Ford-Focus-Mileage-Programming-after-Replacement-by-Launch-X431-5

It can only enter a value higher than actual mileage.(Now Mileage:34531Miles)
Europe-Ford-Focus-Mileage-Programming-after-Replacement-by-Launch-X431-6

If you enter a value lower than actual mileage,it show as below
Europe-Ford-Focus-Mileage-Programming-after-Replacement-by-Launch-X431-7

Press ok to reenter
Europe-Ford-Focus-Mileage-Programming-after-Replacement-by-Launch-X431-8

when you enter a correct data, it will show as below
Europe-Ford-Focus-Mileage-Programming-after-Replacement-by-Launch-X431-9

Press ok to Complete.
Europe-Ford-Focus-Mileage-Programming-after-Replacement-by-Launch-X431-10

Done!

Be the first to comment

Leave a Reply

Your email address will not be published.


*