How to setting new CAT Messenger Display?

How to setting new CAT Messenger Display: SOFTWARE INSTALLATION REQUIRED

NEW - CAT - Messenger - Display - 1

Read More:
Change Units of Measure on CAT Messenger Display
Change Measurement System on Caterpillar ET Software

Here the STEPS:
1. Connect CAT ET Software, after connected it will showing information/message box “Select one of the following ECMs ..”, the second list, “Blank Box (Flash Required)”, that’s what gonna do today. Please choose the first list.

NEW - CAT - Messenger - Display - 2

2. Click on Menu “Utilities”, then “WinFlash”.
-Click on Blank ECM J1939 S/N: 3208B019HL, then Load Flash File (for CAT Messenger), you can download it here 3145001.FLS

NEW - CAT - Messenger - Display - 3

-Click “Load Product Flash File”, and please wait the process (Flash in progress) until 100%

NEW - CAT - Messenger - Display - 4 NEW - CAT - Messenger - Display - 5

-When the process is completed, will showing message box “Flash Completed Successfully”, and New S/W Part # : 3145001-00.

NEW - CAT - Messenger - Display - 6

-New S/W Part # : 3145001-00 will showing while power up CAT Messenger Display (right-above side), or through “Service”, then “System Version”, and look at SW Part Number on CAT Messenger Display.

NEW - CAT - Messenger - Display - 7 NEW - CAT - Messenger - Display - 8

NOTE:
WinFlash – only on CAT ET with Full Dealer Service, not available on Full Customer Service version.

Read More:
FREE Setting CAT ET-2018C Full Service Dealer, Diagnostic Software for Caterpillar Engine
FREE Setting CAT ET-2019A Full Service Dealer, Diagnostic Software for Caterpillar Engine

Be the first to comment

Leave a Reply

Your email address will not be published.


*